Bitpen mini — Quick Start Guide

⚙️ Commissioning

1. Unpacking: Take the pen out of the wooden box.
2. Connection: Connect to a 5V / max. 3A power source using a USB-C cable.
3. How to hold: Grip it like a normal pen, place your index finger on the orange button .
4. Start: Hold down the orange button → tip beats approximately 50 times per second (~0.2 mm deep).
5. Engraving:
   1. Apply no pressure , just glide lightly over the metal.
   2. For deeper engraving, stay in one spot longer.
   3. It's best to hold it vertically , but holding it at an angle is also possible.
6. Stop: Release button → pen stops immediately.
7. Storage: Disconnect from the power supply, place back in the wooden box and close it.

---

🔒 Safety & Behavior

• Never point towards eyes or people!
• Do not take photos or voice memos of the seed words.
• Only you are allowed to know the seed phrase — it grants full wallet access.
• Use only suitable metals :
  • ✅ Bitpen Cold Wallets (recommended)
  • ✅ Aluminum, stainless steel, titanium Grade 1
  • ❌ No hardened steels — tip can break!
• If the tip is defective: do not continue using → replacement tip available in the shop.
• Safety goggles recommended.

---

🧰 Technical specifications

• Voltage: 5 V DC (USB-C)
• Current draw: up to 3 A
• Beat frequency: approx. 50 Hz
• Impact depth: ~0.2 mm (depending on the material)
• Operating mode: Push button – On / Release button – Off
• Engraving tip: replaceable

---

🧡 Care & Storage

• Always disconnect from the power supply before cleaning.
• Remove metal dust with a brush or cloth (do not blow it out!).
• Store in a dry, cool place and out of reach of children.
• Check the tip regularly — replace worn tips.
• Never immerse the device in liquids.

---

❗ Quick troubleshooting guide

---

🛠️ Replacement & Support

➡ Replacement tips and compatible cold wallets can be found in the Bitpen shop